Viewports

27/01/08

I talked to people in the club and finally decided on this method of repair.  I heated the hole and area around it to red hot.  Then while it was still very hot, I quickly filled the hole with weld.  I then left it to cool down slowly.  Once cold, I filed it down and I’m back to square one.  But, I’m still not sure how it will drill.  I suspect that I will drill through the weld, and then come up against the hard bit again.  I’m not sure what to do now.  I might take it to a professional shop to have it done.  I don't need this port yet, so I’m having a think about it….

Submersible Build Log