Tower Base |
20/8/07 |
It didn't really matter that I could only do one half. I had cut just to the outside edge of the line to be “on the safe side” and as such there was a lot of grinding to do. This was really a pain and when I cut the other side, I’m going to cut it right on the line and just make sure I keep a steady hand. It will save a lot of grinding.. The second picture is about half way through the neighbour annoying grinding. Incidentally, I used a different grinding disk called “Euro Cut”. I’ve not used them before but it lasted ages longer than the others I use. I’ll put a link on the “suppliers” bit in a minute as they were so good. |
Submersible Build Log |