25/10/10

Business Name

Drop Weights

As the weights were not quite heavy enough, I added some angle around the top of the original mould so I could pour extra lead on top.  Then I screwed in 10 A4 stainless screws leaving just the heads poking out.  Using the same procedure as before, I melted about 10kg of lead and poured it onto the top.  It worked ok but it’s a good job I added the screws, otherwise the extra “layer” would just fall off.  Now weighs 156 lb so that gives me a bit of leeway to tidy them up.  Both weights are now complete.  Pictures to follow.

Submersible Build Log