10/03/13 |
Business Name |
Motors |
Submersible Build Log |
Soldered the sub conn penetrator cables to fit to the aft motor. As I am using 2 cables for both positive and negative terminals, I used these large solder on battery connectors. I had to use the big gun soldering iron and blow torch to get enough heat on it. I staggered the cables so they cannot come into contact, and the whole lot will be potted in epoxy the same as the lights. I was careful to make sure I was connecting the correct cables together. The wrong 2 wired together would create a very high powered short. There is a circuit breaker mind, but it still might damage the controller or something. |